![]() I soldered it and it was good after that. In my case, one of the soldering strips of the white cylinder at the tip was cracked. Once you determine where they terminate, you can take a measurement there too. One goes to a plated through hole and the other goes somewhere under the 68 microfarad 10V black capacitor. You should receive 100 ohms or less.ģ) Follow the tracks from both sides. These points are the weak points that have cracks that you may not see easily. If not you have a break in the coil wire typically at where it is soldered to the posts.Ģ) The next point to measure is at both sides of the white cylinder where the posts are soldered to the tracks. If you are good with a multimeter, you can check the resistance of the coilġ) at the tip of the coil where the coil wire ends are soldered to the the two posts. ![]() The four tracks center coming out of the white barrel has one outer to plated hole and Question: Can you clarify multimeter number three (3) check belowīecause if I follow the white cylinder tracks one goes to the 10V black capacitor and one goes to the Motorola chip. Visual inspection of board no noted solder breaksġ) I have 7.4 ohms the tip of coil two postsĢ) I have 7.4 ohms both sides white cylinder posts at tracksģ) Question: Can you clarify multimeter number three (3) check below
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |